Sitemap  ¿ÚA New Message!   Favorite  
 
PRODUCTS
The First Article | The Last Article

Wood coating

2015/7/20 7:33:40    


Wood coating
This serious of products has the advantages of high extinction,high transparency,easy dispersion, high porosity,good resistance to water, with yellow phase,water and oil GMC etc
1.High rate of extinction-various sizes of particles just meet the requirements of the paint recipe,extinction rate is higher, the particle size distribution and narrow symmetrical extinction rate is high.
2.Good transparency - extinction powder through the arrangement of science, the refractive index of refraction index and film-forming resin,to avoid the possible extinction transparent paint white mist.
3.Easy to disperse-control of the particle size distribution makes it easy to disperse in the paint,for the standard solution,as the speed of 1200r/mm(blade speed of 5-6m/s)mixing impeller dispersed 10-15 minutes, it can be fully dispersed,attention that temperature should be controlled below 50¡æ
4.No effect for film-the purity of extinction powder,the integrity of the particle size, the special characteristics of abrasion resistance and reasonable choice of the grinding characteristics matching models, not only have no effect on the film recoat adhesion, but also it will be good for abrasion resistance and coating smooth, the hand feeling will be much better, gloss consistent will be better too.

High transparency
This series of products using special surface coating treatment process,has greatly improved refractive index,matting to refraction coefficient of 1.47, and closed to the refractive index 1.4-1.6 of the resin,greatly improve the transparency of the product.

High extinction ratio
Porosity of 1.8-2.0mm/g, the production equiqment and process was optimized to make products with more narrow particle size distribution,greatly improved the extinction efficiency.

High dispersion
Through the most advanced grinding technology,matting agents can also easy to disperse in extremely adverse conditions, shorten the operation time, and more conducive to add matting agent to adjust dumb degrees.

Instructions:
1.If you want to reach dry matting matting efficiency,recommended to add 3-10%
2.Due to different formulations and conditions, we advice you to make a test to get the optimal dosage before final application.

Precautions:
1.During the process of handling and transportation, to take the necessary measures to avoid dust.highly recommends no more that 10layers, the dispersion of the produc would be effected by extrusion, please extend the dispersion time appropriately.
2. To avoid to be affected by damp.
 
The First Article | The Last Article
QINGDAO BOZEWON INTERNATIONAL TRADE CO.,LTD
TEL:0532-85650601 FAX£º0532-85650601 E-MAIL£ºsales@bozewon.com
NO.628,Sichuan Road,Qingdao,China

Powered by jukebao 6.1.0,jukebao.com